 Chief Sales Officer |
Body ArmorAshley Products | ||
|
IN ORDER TO INSURE A PROPER FIT ON YOUR ARMOR, PLEASE READ ALL INSTRUCTIONS COMPLETELY BEFORE BEGINNING
|
USE THE SIZING CHART BELOW TO HELP DETERMINE THE PROPER SIZE NEEDED
|
These drawings illustrate the difference between the SP Contour model and the SP Side Panel model. The Contour model has a standard width back panel while the width of the Side Panel model back panel varies depending on the size ordered. |
Chest: inches Measure completely around the chest at nipple height with arms at sides. make sure to keep the tape at an equal height around the chest. |
|
Waist: inches Measure completely around waist just above belt height. Stand normally and DO NOT SUCK IN YOUR STOMACH OR HOLD YOUR BREATH. |
Front (standing) inches Measure from the second shirt button (the collar button is the first button) down to the top, center front edge of the gun belt. |
|
Front (sitting) inches Repeat the same procedure as Front Standing while seated. Sit comfortably. DO NOT SIT SLOUCHED OR RIGIDLY UPRIGHT. |
Back inches Place the top of the tape as shown. (Position should be 4 inches down from the collar seam.) measure to the top, center back edge of the gun belt. |
|
Belt to Belt inches Measure from the top edge of the gun belt (in the back) over the center of the shoulder ... |
.... to the top edge of the gun belt in the front. Be sure tape is straight down the front and back. (Notice that the tape measure on the front lies on top of the shirt pocket.) |
:
Armor Panels require a 2' to 2 1/2" gap between the gun belt and the bottom of
the vest when standing. This open area is necessary to prevent the vest
from riding up while seated.
Orders are normally shipped by USPS Priority Ground Service so please be sure to include a street address and not a Box number.Air Express Delivery service is also available for Local and International deliveries, please request quotation. Normal delivery time is 2 - 3 weeks unless for special orders or imports.
